Instruction Manual

23E-flite BAe Hawk ARF Assembly Manual
Nose Gear and
Elevator Servo Installation
Required Parts
Radio system Assembled airframe
Pushrod connector (2)
Servo w/hardware (2)
2x4mm machine screw (2)
Servo arm, single-sided (2)
3-inch (76mm) servo extension (2)
2mm nut (2) #2 washer (2) (optional)
Required Tools and Adhesives
Pencil Thin CA
Pin drill Phillips screwdriver: #1
String/dental floss Drill bit: 5/64-inch (2mm)
Side cutters
 1. Secure a 3-inch (76mm) servo extension to
the steering servo. Use dental floss to secure the
connectors together. Use a #0 Phillips screwdriver
to remove the servo arm from the servo.
 2. Position the elevator servo in the fuselage with
the output of the servo facing toward the elevators.
Use a pencil to mark the locations for the two servo
mounting screws onto the radio tray.
 3. Remove the servo and use a pin drill and
1/16-inch (1.5mm) drill bit to drill the two holes
for the servo mounting screws.
 4. Place 2–3 drops of thin CA into each hole to
harden the surrounding wood,. This will provide a
harder surface for the screws to bite into, making
them more secure.
 5. Secure the elevator servo using the two screws
that were provided with the servo.