Manual

32 E-flite AT-6 Texan ARF Assembly Manual
 6. Remove the covering to expose the entire opening for
the retract.
Hint: Trim the covering about 1/16-inch (1.5mm) from
the inside edge of the opening and use a covering iron
to seal the covering into the opening for a super clean
retract installation.
 7. Position the main gear on the rails of the wing center
section. Use a pencil to transfer the locations for the four
mounting screws through the gear and onto the rails.
 8. Use a drill and 5/64-inch (2mm) drill bit to drill the
four holes for the mounting screws. Use care not to
accidentally drill through the top of the wing.