AT-6 1.5m Manual

EN
8
AT-6
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the Spektrum AR636 manual for
adjustment of gain values.
After ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Horns Arms
Elevator
Elevator
Flaps
Tail wheel
Ailerons
Elevator
Flaps
Tail wheel
Elevator
Flaps
Tail wheel
Flaps
Elevator
Flaps
Tail wheel
Rudder
Elevator
Flaps
Tail wheel
More control throw Less control throw
Elevator
Flaps
Tail wheel
Elevator
Flaps
Tail wheel
Elevator
Flaps
Tail wheel
SAFE
®
Select Switch Designation
SAFE
®
Select technology can be easily assigned to any open switch (2 or 3
position) on your transmitter. With this new feature, you now have the exibility
to enable or disable the technology while in ight.
IMPORTANT: Before assigning your desired switch, ensure that the travel for
that channel is set at 100% in both direction.
Assigning a switch
1. Bind the aircraft correctly to activate SAFE Select. This will allow the system
to be assigned to a switch.
2. Hold both transmitter sticks to the inside bottom corners and toggle the
desired switch 5 times (1 toggle = full up and down) to assign that switch.
The control surfaces of the aircraft will move, indicating the switch has
been selected.
Repeat the process to assign a different switch if desired.
NOTICE: SAFE Select is assignable on any unused Channels 5–9.
Mode 1 and 2 Transmitters
x 5
100%
100%
3 position Switch
2 position Switch