User Manual

EN
Model Assembly Continued
Horizontal Tail Installation
1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the
control horn faces down.
3. Install 2 screws (B) in the holes in the bottom of the horizontal tail.
4. Attach the ball link (C) to the elevator control horn’s outermost hole using
the included nut (D) and screw (E).
Tip: Use needle-nose pliers or ball link pliers (RV01005) to remove or install a
link on a control horn.
5. Ensure the elevator servo arm is in the correct position, then adjust the
linkage to center the elevator.
When needed, disassemble in reverse order.
A
B
3 X 12mm
C
D
M2 lock nut
E
2 x 8mm
7