User Manual

EN
Model Assembly Continued
Rudder Installation
1. Slide the rudder’s CA hinges (A) into the hinge slots (B) of the vertical tail.
Make sure to place the tail light and wire (C) on the left side of the rudder.
2. Rest the aircraft on its nose, holding the tail up so the thin CA
(cyanoacrylate adhesive) will flow into the slots.
3. Bend the hinges by turning the rudder left, then carefully apply thin CA to
each hinge in the right side of each slot.
4. When the CA is dry, turn the rudder to the right and apply CA in the left
side of each slot.
5. Place the tail light wire in the groove (D) and secure it into place with the
included red tape (E).
6. Insert the LED (F) into the tail light housing (G), then secure the tail light
housing onto the edge of the rudder using CA.
7. Connect the ball link (H) to the rudder control horn (I) using a screw (J)
and nut (K). Ensure the rudder servo arm is in the correct position, then
adjust the ball link on the linkage to center the rudder.
When needed, disassemble in reverse order.
Required Adhesives:
Thin CA
A
B
D
E
F
G
H
I
C
H
K
M2 lock nut
J
2 x 8mm
6