User Manual

EN
Model Assembly
Main Gear Installation
1. Place the two main landing gear halves (A) into the pocket on the bottom
of the fuselage.
2. Secure them into place using the mounting plate (B) and 6 included
screws (C).
When needed, disassemble in reverse order.
A
B
Nose Gear Installation
1. Remove the battery hatch (D) to access the
location where the nose assembly screws will
be installed.
2. Connect the nose gear pushrod (E) to the nose
gear steering arm (F) using the included nut
and bolt as shown. Part of the box surrounding
the steering arm has been removed to show
steering arm.
3. Remove the clasp (G) at the end of the
nose gear pushrod and install the nose gear
assembly into the fuselage leading with the
pushrod.
4. Use the arrows on the bottom of the main
mount to install the front gear in the correct
direction. The arrows point to the front.
5. Guide the pushrod up into the fuselage to meet
with the servo horn.
6. Secure the nose gear assembly into place
using the 2 included screws (H).
Continue nose gear installation on next page.
E
F
G
D
C
3 X 18mm
H
3 X 12mm
M2 lock nut
E
2 x 8mm
4
Prefl ight
1 Remove and inspect contents.
2 Read this instruction manual thoroughly.
3 Charge the fl ight battery.
4 Fully assemble the airplane.
5 Install the fl ight battery in the aircraft (once it has been fully charged).
6 Check the Center of Gravity (CG).
7 Bind the aircraft to your transmitter.
8 Make sure linkages move freely.
9 Perform the Control Direction Test with the transmitter.
10 Perform the AS3X Response Test with the aircraft.
11 Adjust fl ight controls and transmitter.
12 Perform a radio system Range Test.
13 Find a safe open area to fl y.
14 Plan fl ight for fl ying fi eld conditions.