User Manual

The table to the right shows the factory settings for the control horns and servo

arms. Fly the aircraft at factory settings before making changes.

After ﬂ ying, you may choose to adjust the linkage positions for the desired

control response. See the table to the right.

IMPORTANT: If control throws are changed from the factory settings, the

AR636 gain values may need to be adjusted. Refer to the Spektrum AR636

manual for adjustment of gain values.

Control Horn and Servo Arm Settings

Factory Settings

Horns Arms

Elevator

Rudder

Ailerons

Flaps

More control throw Less control throw

SAFE

Select Switch Designation

SAFE

Select technology can be easily assigned to any open switch (2 or 3

position) on your transmitter. With this new feature, you now have the ﬂ exibility

to enable or disable the technology while in ﬂ ight.

IMPORTANT: Before assigning your desired switch, ensure that the travel for

that channel is set at 100% in both direction.

Assigning a switch

1. Bind the aircraft correctly to activate SAFE Select. This will allow the

system to be assigned to a switch.

2. Hold both transmitter sticks to the inside bottom corners and toggle the

desired switch 5 times (1 toggle = full up and down) to assign that switch.

The control surfaces of the aircraft will move, indicating the switch has

been selected.

Repeat the process to deselect the switch or to assign a different switch if

desired.

NOTICE: SAFE Select is assignable on any unusable Channels 5–9.

Mode 1 and 2 Transmitters

x 5

100%

3 position Switch

2 position Switch

Nose Gear