Owner manual

Note: One float has holes drilled in the aft end
for the rudder bracket. This float is mounted on
the same side as the rudder linkage.
Linkage Installation
Required Parts
• Fuselage w/floats • Nylon bracket
• Steering arm • 5/32" wheel collar
• 3mm setscrew (4) • Pushrod connector (2)
• Rudder shaft assembly • Tie wrap
• Full brass strap (3) • Connector backplate (2)
• 3mm x 12mm sheet metal screw (4)
• 29
3
/
4
" (755mm) pushrod cable
• 25
3
/
4
" (655mm) pushrod tube
• 2mm x 10mm sheet metal screw (6)
Required Tools and Adhesives
• Phillips screwdriver • Hobby knife
• Pliers • Threadlock
• Drill • Drill bit: 5/64" (2mm)
• Hex wrench: 1.5mm, 3/32”
20