User's Manual

Table Of Contents
INDEX
61
Transceiver Service
If your transceiver is not operating properly, “OUT-LOCK”, “PROG
ERR”, “SLEEPING”, or “CALL SVC” may be displayed. It may be
possible to clear the first two conditions by turning power off and then on
again to reset the control logic. Also, make sure that the controls are
properly set and the battery is fully charged. If the transceiver still does
not operate properly, return it to your system operator for service.
The “SLEEPING” message indicates the transceiver is temporarily
disabled as described on page 57. If the CALL SVC message is
displayed, the transceiver must be returned to your system operator for
service.
NOTE: There are no user serviceable components in the transceiver.
Altering internal adjustments can cause illegal emissions, void the
warranty, and result in improper operation that can seriously damage the
transceiver.
INDEX
A
Accessory Connector 12
Alpha Tag Display Mode 21
Alphanumeric Display 13
Antenna Jack 12
Auxiliary Call 47
Placing 33
Receiving 34
B
Backlight 20
Battery Pack 58
Battery Release Button 12
Busy Queuing 47
Busy Tone 53
C
Call Guard Squelch 52
Call Indicator 14, 25
Clear-to-Talk Tone 27
CLR Key 16
Controls
On-Off/Volume
11
Option Switch 12
PTT Switch 12
Top Panel 11
Conventional Mode 24
Conventional Mode Scanning 43
D
DIAL Key 17
Dial Mode 38
Exiting 40
Selecting 38
Dialing a Number 39
Directed Group Call 33, 47
Disabling Keypad 22
Display 13