User's Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- QUICK REFERENCE GUIDE
- FEATURES
- CONTROLS AND DISPLAY
- BASIC OPERATION
- GENERAL FEATURES
- STANDARD GROUP CALLS
- TELEPHONE CALLS
- LTR-NET AUXILIARY CALLS
- OPTION SWITCHES AND MENU MODE
- DIAL MODE
- SYSTEM AND GROUP SCANNING
- LTR-NET AND LTR FEATURES
- LTR-NET FEATURES
- LTR FEATURES
- CONVENTIONAL FEATURES
- MISCELLANEOUS
- INDEX
- TABLE OF CONTENTS
DIAL MODE
39
Dialing a Number
Enter the desired number by pressing the 0-9, , and keys. Other
dialing functions are as follows:
• Only the last 8 digits dialed are displayed. To momentarily display
the upper 8 digits, press FCN .
• To erase the last digit, press the CLR key (hold it down to repeat). To
erase the entire number, press FCN CLR.
• To enter a pause, press FCN (each pause equals one character).
Sending the Number
To automatically access the radio system and send the number in the
display, press FCN SND. The keypad remains active while in a conversa-
tion to allow additional numbers to be dialed. Simply press the PTT
switch and dial the number. The number in the display does not change
when a number is dialed in this manner. If you want to save the number in
the display (see following information), make sure you do so before the
dial mode is exited.
Storing Numbers in Memory
Up to ten 16-digit numbers can be stored in memory and later
recalled. Proceed as follows to store a number:
1. Enter the number as described in the preceding “Dialing a Number”
section.
2. To store the number, press FCN STR and the memory location from
0-9.
3. If there is already a number in the selected location, it is replaced by the
new number. To clear a memory location, simply store a blank display.
#