User's Manual

ManualsBrandsE F Johnson ManualsElectronicsUHF FM Handheld Transceiver Held-to-face

Table Of Contents

SAFETY INFORMATION
IMPORTANT OPERATING INFORMATION
QUICK REFERENCE GUIDE
FEATURES
- General Features
- LTR-Net Features
- LTR Features
- Conventional Features
CONTROLS AND DISPLAY
- Top Panel Controls
- Side Controls
- Display
- Front Panel Keys
BASIC OPERATION
- Power-Up Sequence
- Backlight Operation
- Setting Volume Levels
- System/Group Display Mode
- System and Group Select
- Keypad Disable
- Transceiver Lock
- Low Battery Indication
- Option Switches
- LTR-Net, LTR, and Conventional Operation
GENERAL FEATURES
- Bank Select
- Call Indicator
- Emergency Switch
- Encryption
- Home System/Group Select
- Option Select
- Power Select
- Proceed (Clear-To-Talk) Tone
- Receive-Only Groups
- Stealth Mode
- Time-Out Timer
- Tone Select
STANDARD GROUP CALLS
- General
- Placing a Standard Group Call
- Receiving a Standard Group Call
TELEPHONE CALLS
- General
- Placing Telephone Calls
- Receiving a Telephone Call
- Landside-Originate Telephone Calls
LTR-NET AUXILIARY CALLS
- General
- Placing LTR-Net Auxiliary Calls
- Receiving Auxiliary Calls
OPTION SWITCHES AND MENU MODE
- Option Switches
- Menu Mode
DIAL MODE
- Introduction
- Selecting Dial Mode
- Dialing a Number
- Sending the Number
- Storing Numbers in Memory
- Recalling Numbers From Memory
- Exiting Dial Mode
- Placing Calls Without Selecting Dial Mode
SYSTEM AND GROUP SCANNING
- General
- Scan List Programming
- Scan Delay and Continue Timers
- Transmitting In The Scan Mode
LTR-NET AND LTR FEATURES
- Transmit Inhibit
- Priority Calls
LTR-NET FEATURES
- LTR-Net Standard Calls
- LTR-Net Special Calls
- Busy Queuing
- Roaming
LTR FEATURES
- Standard Group Calls
- Telephone Calls
CONVENTIONAL FEATURES
- Squelch Adjust
- Monitoring Before Transmitting
- Transmit Disable On Busy
- Talk-Around
- Call Guard Squelch
MISCELLANEOUS
- Supervisory Tones
- LTR-Net Special Call Tones
- LTR Telephone Call Tones
- Display Messages
- Menu Mode Messages
- Rechargeable Battery Pack
- Speaking Into Microphone
- Operation At Extended Range
- Licensing
- Transceiver Service
INDEX
TABLE OF CONTENTS

CONVENTIONAL FEATURES

Monitor Mode

There may be times when the Busy indication is displayed even

though no one is using the channel. Monitoring should then be performed

using the monitor mode. This mode is enabled by pressing the Monitor

option switch (see page 35), and is indicated by in the display as

shown in the following illustration. While this switch is pressed, both

Call Guard squelch (see page 52) and scanning are disabled so that any

activity on the group is heard.

A conventional system must be selected to enable monitoring. If the

Monitor option switch is pressed with an LTR-Net or LTR system

selected, scanning halts but monitoring is not enabled.

Transmit Disable On Busy

The Transmit Disable On Busy feature automatically disables the

transmitter if the selected group (channel) is busy and it has not been

monitored when the PTT switch is pressed. When the transmitter is

disabled by this feature, the busy tone sounds briefly and “DSBL BSY” is

indicated in the display as follows:

While the PTT switch is pressed, the receiver is enabled so that

activity on the channel can be monitored. The PTT switch must be

BUSY

Busy

Indicator

Monitor Mode

Selected