User's Manual

TELEPHONE CALLS
32
• To select the dial mode and a preprogrammed telephone group, press
FCN PHONE.
• To select the dial mode without changing the selected group, press
FCN DIAL. Then manually select a telephone group if required.
3. Dial the desired number using the keypad or recall it from memory by
pressing FCN RCL and the location number (0-9). Refer to the dial
mode description starting on page 38 for more information.
4. To automatically access the radio system and send the telephone
number, press FCN SND. Landside ringing (or a landside busy condi-
tion) should then be heard.The following conditions may also occur:
• If the radio system is busy or could not be accessed, busy or no
access conditions may be indicated the same as described for stan-
dard group calls on page 30.
• With LTR-Net operation, a short tone sounds to indicate that the
number was accepted by the system.
5. When the other party answers, press the PTT switch and respond. The
PTT switch must be pressed to talk and released to listen the same as
with standard group calls.
6. When the call is finished, it should be terminated and the dial mode
exited. The call is usually terminated by transmitting either the or
characters.
To automatically send these characters and exit the dial mode, press
FCN PHONE. To exit the dial mode without sending these characters,
press FCN DIAL. Termination is indicated by three beeps. Terminating
the call in this manner prevents extra billing that may occur while the
system automatically detects the end of the call.
#
#