User's Manual

TELEPHONE CALLS
31
Receiving a Standard Group Call
1. Select or scan the system and group programmed for the call you want
to receive (see page 41 for scan information).
2. When the message is received, the display changes to the system and
group of the call. Press the PTT switch to talk and release it to listen. If
scanning, a response may not automatically occur on the group of the
call. Refer to “Transmitting In The Scan Mode” on page 45 for more
information.
TELEPHONE CALLS
General
NOTE: Telephone calls can be placed and received only if that service is
available to you and your transceiver has been programmed appropri-
ately.
The telephone calling feature allows you to place and receive tele-
phone calls using your transceiver. The following information describes
how these calls are made with LTR-Net and LTR operation. If you can
make telephone calls with conventional operation, the procedure may be
somewhat different and your system operator may provide additional
information. Proceed as follows:
Placing Telephone Calls
1. Turn transceiver power on and set the volume as described starting on
page 20.
2. Select the dial mode and a telephone group as follows. When the dial
mode is selected, the handset portion of the telephone icon is
displayed, and then when a telephone group is selected, the base portion
is displayed.