Product Info

Draft 2/8/12
2-4 Viking Portable Radio Service Manual
Battery, Accessory and Disassembly Information
2.2 Belt Clip Installation
Remove the battery and slide the beltclip into the slot on the battery until it locks into place
(see Figure 2.2). To remove the beltclip, squeeze the tab on the end of the beltclip and
slide the beltclip out.
Figure 2.2 Belt Clip Installation
2.3 Accessory Installation
To connect an accessory such as a speaker-microphone to the radio, refer to Figure 2.3 and
proceed as follows:
1 Remove the dust cover over the accessory connector on the side of the radio. The most
effective way to do this is to insert a flat-blade screwdriver into the slot at the top of the
dust cover, and apply a gradual lift-and-twist motion.until the cover separates.
2 Insert the hook of the accessory connector into the slot on the side of the radio.
3 Hold the latch open, press the connector against the radio, and then release the latch to
lock the connector in place.
Beltclip
Locking Tab
Beltclip
Locking Tab
Beltclip
Locking Tab
Beltclip
NEEDS TO BE REPLACED