User's Manual

Draft
December 2006 5300 ES Series Mobile Radio Operating Manual -11
user programming is disabled on a list (conventional channels only), “NO EDIT” is
momentarily displayed and it cannot be edited.
4 Select the channel you want to add or delete by rotating the Select switch. After the last
channel in the current zone is displayed, the first valid channel in the next zone is
displayed and vice versa. Lists are limited to 256 channels. If an attempt is made to add
more than 256, “LIST FULL” is displayed and a channel must be deleted before
another can be added.
Note Priority channels can be deleted.
5 If the selected channel is in the scan list (scanned), the symbol is displayed next to
the zone number as just described. To change the scan list status of the displayed
channel, press the Select switch.
With conventional channels only, if the selected scan list is programmed with fixed
priority channel(s), the next press of the Select switch makes the current channel the
priority channel indicated by “P” in the left status display next to the zone number. If
dual priority channels are used, pressing the Select switch again makes it the second
priority channel indicated by “2” in the left status display. Then pressing the Select
switch again takes the channel out of the scan list. Refer to Sections
5.10.2 and 5.10.3
for more information on priority channel sampling.
6 To exit this mode and save the changes, press the SCN ED option switch again.
4.12.2 Radio Wide Scan List
With radio wide scanning, there is only one scan list available regardless of the type of
channel selected. This list is user programmable in later models*, and it can include up to
16 channels of any type. For example, it could include six conventional channels and ten
SMARTNET/SmartZone channels. More information on selecting and editing radio wide
scan lists follows.
4.12.2.1 Determining Channels in Radio Wide Scan List
The channels in early model radio wide scan lists are indicated by selecting the radio wide
scan mode. With later models*, they can be determined only by selecting the scan list edit
mode (see “Editing Radio Wide Scan List” which follows).
When the displayed channel is in the scan list (scanned normally), the symbol is
displayed next to the zone number as shown in the following illustration.