User's Manual

3-10 5300 ES Series Mobile Radio Operating Manual March 2008
General Operation
The radio cycles through several informational displays, which are described in Table 3.1.
To stop a display, press <F2>. To continue displays, press the <F3> button. To quickly
cycle through the displays, continue to press <F3>. You cannot go back to displays that
have already been shown.
Upon completion of the information displays, the radio enters a menu mode. The default
option is the RF Test Mode, and the message, “RF TEST”, is displayed.
As there is only one other test mode, Control Top and Keypad Test Mode (displaying the
message “CH TEST”), pressing <F2> cycles between these two modes. Pressing the F1
allows the user to enter into the test mode that is currently displayed.
3.8.1 RF Test Mode
In the RF Test Mode, the radio has a set number of frequencies and tests that can be run
depending on the radio’s band. The frequencies that can be tested are summarized in Table
3.2 and the test environments are summarized in Table 3.3. The user can press <F2> to
advance to the next test environment and press <F3> to advance to the next test channel.
Table 3.1 Initial Messages
5300 ES Description
SERVICE Test Tune Mode initial message
FIRMWARE Firmware display message
V X.Y.Z Firmware version number
DSP DSP display message
V X.Y.Z DSP version number
SEM SEM display message
V X.Y SEM version number
FILE FORM. File format display message
V X.Y File format version number
BOOTLOAD Bootload display message
V X.Y Bootload version number
ESN ESN display message
XX-XX-XX-XX-XX-XX-XX-XX* ESN of the radio (in hexadecimal)
BAND Band display message
[VHF, UHF, UHF HIGH, UHF 380, 700/800, 800, 900] Band of the radio
* Scrolling Message