User's Manual

MISCELLANEOUS

Licensing

A government license is usually required to operate this transceiver

on the air. Your system operator will normally handle the licensing

requirements.

Transceiver Service

If “UNPROGRAMD” is displayed, the cause could be any of the

following:

• An unprogrammed channel is selected. Select a programmed

channel.

• The selected channel is programmed for an option that is not installed

or an error in programming was detected. Contact your system operator

for service.

If no characters or all characters appear in the display, the viewing

angle may be incorrect. Refer to page 17 for more information. If some

other problem is occurring, turn power off and then on again to reset the

control logic. Also make sure that the controls are properly set and that

the power, external speaker, and accessory cables (if used) are securely

plugged into the back of the transceiver. If the transceiver is completely

inoperative, check the power cable fuse that is usually located near the

vehicle battery. If it is blown, remedy the cause if possible and replace it

with the same type (15A). If the transceiver still does not operate prop-

erly, return it to your system operator for service.

NOTE: There are no user-serviceable components in the transceiver.

Altering internal adjustments can cause illegal emissions, void the

warranty, and result in improper operation that can seriously damage the

transceiver.