User's Manual

SMARTNET/SMARTZONE FEATURES

mode may be programmed depending on the capabilities of the radio

system. Operation in both modes is described in the following informa-

tion. The

CALL option switch is required to place these calls, and either

that switch or the

RESP (Response) switch is required to receive them.

Proceed as follows.

Placing an Enhanced Private Conversation Call

1. Momentarily press the CALL (Private Call) option switch. The tag

(alias) of the last called mobile is displayed.

2. To select another mobile, rotate the Select switch until the tag for the

desired mobile is displayed.

3. Press the PTT switch and one of the following events then occurs:

• If the mobile being called is on the air, “WAIT” is displayed and

ringing is heard until the called party answers or for 20 seconds,

whichever occurs first. When the call is answered, the voice of the

called party is heard.

• If the called mobile does not answer within 20 seconds, a continuous

tone sounds and “NO ANS” is displayed.

• If the called mobile is not on the air, a continuous tone sounds instead

of the ringing tone and “NO ACK” is displayed.

• If the busy tone sounds and “BUSY” is displayed, the called mobile

has answered the call but the system is busy. When the system is no

longer busy, the call back tone sounds.

• If your transceiver or the called transceiver is inhibited or not

programmed to make this type of call or for the requested secure

mode, “REJECT” is displayed and an alert tone sounds.

• If your transceiver does not have the proper encryption key,

“KEYFAIL” is displayed and the call must be made in the clear mode