User's Manual

SMARTNET/SMARTZONE FEATURES

• If in the secure mode and your transceiver does not have the proper

encryption key, “KEYFAIL” is displayed and the call must be made

in the clear mode.

• If the busy tone sounds and “BUSY” is displayed, the system is busy.

Release the PTT switch and wait for the call back tone to sound. Then

press the PTT switch within 3 seconds.

• If a continuous tone sounds and “NO SYS” is displayed, you may be

out-of-range. Drive closer or away from shielding objects and try

again.

• If your unit ID is invalid, the call is being made to an invalid group

ID, or if the talk group is not programmed for the selected secure

mode, “DISABLED ID” is displayed and an alert tone sounds.

• If an attempt is made to select the secure mode and there is no avail-

able secure channel, “NO SEC” is flashed and the call continues in the

clear mode.

• If an attempt is made to change from the secure to the clear mode and

this is not permitted, “SEC ONLY” is displayed and the call continues

in the secure mode.

Receiving a Standard Call

Group calls are automatically received if a SMARTNET/SmartZone

channel is selected. The display alternates between the selected channel

tag (alias) and the received talk group tag. The transceiver may also be

programmed so that the individual ID of the mobile placing the call is

briefly displayed before this information.

Private (Unit-To-Unit) Calls

General

Private calls allow you to place a call to a specific mobile unit.

Either the Enhanced Private Conversation™ or Private Conversation II™