User's Manual

SMARTNET/SMARTZONE FEATURES

Introduction

An overview of the SMARTNET/SmartZone operating mode is

located on page 27. The following information describes the features

unique to the SMARTNET and SmartZone operation. Refer to the

“General Operation” section starting on page 17 for information on

features common to all operating modes.

Viewing Unit ID

When power is turned on with a SMARTNET/SmartZone channel

selected, the six-digit Unit ID is briefly displayed as IDxxxxxx.

Standard Group Calls

Standard calls are between you and another mobile or control

station. Most calls you make will probably be this type.

Placing a Standard Group Call

1. Turn power on and set the volume as described on page 17. Select the

channel programmed for the talk group you want to call (see “Zone/

Channel Select” on page 18). A regular or announcement talk group

can be selected.

2. If encryption is used, it may be automatically selected. If not, select the

secure mode if desired by pressing the

C/S (Clear/Secure) option

switch. Refer to “Secure Communication” on page 26 for more

information.

3. Press the PTT switch and begin talking. A talk permit tone may sound

to indicate when talking can begin. Other indications that may occur are

as follows: