User's Manual

CONVENTIONAL FEATURES
41
and then scroll through the programmed channels by rotating that switch.
When the desired channel is displayed, select it by pressing the Select
switch.
System Parameters
The “SYS PRM” menu parameter selects the conventional mode
timer to be reprogrammed (see following). Press the Select switch to
select “SYS PRM” and then rotate that switch to display the desired
parameter. Then press the Select switch again to select it. If
“PASSWORD” is briefly displayed, the zone password must be entered
as described on page 39 before parameters can be selected.
SCAN TMR - Selects the Scan Hold timer (see “Scan Resume Delay”
on page 22). Rotate the Select switch to decrement/increment the
timer in 0.5-second steps, and press the F2 key (see illustration on
page 39) to disable the timer (set it to 0 seconds). When the desired
value is displayed, store it by pressing the Select switch.
TX TMR - Selects the transmit time-out timer (see page 19). Rotate
the Select switch to decrement/increment the timer in 15-second steps,
and press the F2 key to disable the timer (set it to 0 seconds). When
the desired value is displayed, store it by pressing the Select switch.
PEN TMR - Selects the penalty timer (see page 31). Rotate the Select
switch to decrement/increment the timer in 15-second steps, and press
the F2 key to disable the timer (set it to 0 seconds). When the desired
value is displayed, store it by pressing the Select switch.
CONV TMR - Selects the conversation timer (see page 32). Rotate
the Select switch to decrement/increment the timer in 30-second steps,
and press the F2 key to disable the timer (set it to 0 seconds). When
the desired value is displayed, store it by pressing the Select switch.