User's Manual

CONVENTIONAL FEATURES

Menu Description

A menu system is used to select parameters to be changed in the

keypad programming mode. When the Keypad Programming mode is

selected by pressing the

PROG option switch, the first menu parameter

“ZONE CHG” is displayed as just described. Rotate the Select switch to

scroll through the available parameters which are as follows. Additional

information on these parameters is located in the sections which follow.

• ZONE CHG

• CHAN CHG

• SYS PRM

• CHAN PRM

Press the Select switch or F6 key (see following illustration) to

select the displayed parameter. Press the F5 key from one of the main

menus to exit keypad programming. Pressing the F5 key in the other

menus returns to the previous menu. A flowchart showing the keypad

programming mode menu structure follows in Figure 4.

Key Identification For Keypad Programming

Zone Password

Your transceiver may be programmed so that a special password

must be entered before the system and channel parameters of a particular

zone can be changed. A different password may be required for each

zone. The first time a system or channel parameter of a password-

protected zone is selected by keypad programming, “PASSWORD” is

flashed. The eight-digit password must then be entered by rotating and

pressing the Select switch. After the correct password is entered, the

parameters for that zone can be reprogrammed normally.