User's Manual

CONVENTIONAL FEATURES
33
Pressing the TX PWR switch toggles the power setting. The new
level is flashed in the display when this switch is pressed as “HIGH
POWER” or “LOW POWER”. If selectable power is not permitted on the
current channel, the fixed power level is flashed and no power change
occurs.
Displaying Transmit/Receive Frequency
If the DISP option switch is programmed, it can be used to display
the channel frequency in megahertz. Pressing this switch toggles between
displaying the standard channel identification and the frequency. The
receive frequency is displayed while receiving and the transmit frequency
is displayed while transmitting.
Emergency Mode
An EMER option switch may be programmed for use on conven-
tional Project 25 (digital) channels. This function could be used, for
example, to alert your dispatcher of an emergency condition. If you have
this switch, consult your system operator for more information on how it
is used in your application.
Conventional Mode Scanning
General
The following information describes scanning features unique to
conventional operation. Scan operation common to all modes is described
starting on page 21, and scan operation common to SMARTNET/Smart-
Zone operation is described starting on page 54.
Selecting Scan List
Up to three scan lists are available when standard scanning with a
conventional channel selected. These lists are preprogrammed by your
system operator, and the list to be scanned is selected by the
SCAN
option switch as follows: