User's Manual

GENERAL OPERATION
25
Programming a Scan List
If the SCN ED (Scan Edit) option switch is programmed, conven-
tional and SMARTNET/SmartZone standard scan lists can be user
programmed as follows:
1. Make sure that both standard and radio wide scanning are off (the
rotating icon is not indicated in the right status display). Then press
the
SCN ED option switch and the scan edit mode is indicated by a
triangle in the upper left part of the display (see illustration on page 15).
2. With conventional channels, if applicable, select the list to be edited
(1-3) by rotating and then pressing the Select switch. The scan list is
indicated as “SCAN LIST x” (see page 33). If user programming is
disabled on a list, “NO LIST” is momentarily displayed and it cannot
be edited.
With SMARTNET/SmartZone channels, the scan list for the selected
channel is fixed and cannot be changed. Scanning may also be disabled
on the selected channel in which case “NO LIST” is momentarily
displayed and scan list editing is not available.
3. Select the channel you want to add or delete by rotating the Select
switch. After the last channel in the current zone is displayed, the first
valid channel in the next zone is displayed and vice versa.
SMARTNET/SmartZone lists are limited to 16 channels. If an attempt
is made to add more than 16, “LIST FULL” is displayed and a channel
must be deleted before another can be added.
4. If the selected channel is in the scan list (scanned), the symbol is
displayed next to the zone number as described on page 23. To change
the scan list status of the displayed channel, press the Select switch.
NOTE: The priority channel cannot be deleted (see “Priority Channel
Sampling” description which follows).
5. To exit this mode and save the changes, press the
SCN ED option
switch again.