User's Manual

GENERAL OPERATION

Standard Mode Scan List

NOTE: The selected channel is always scanned.

With conventional operation, up to three scan lists can be

programmed. The list that is scanned is selected by the

SCAN option

switch as described on page 33. Selecting another conventional channel

does not change the current scan list. The scan lists are user program-

mable if the

SCN ED (Scan Edit) option switch is programmed (see

page 25).

With SMARTNET/SmartZone operation, each channel can be

programmed so that one of up to three different scan lists is selected or

scanning is disabled. As with conventional channels, the selected scan list

is user programmable if the

SCN ED option switch is programmed.

Radio Wide Mode Scan List

With radio wide scanning, there is only one preprogrammed scan list

available regardless of the type of channel selected, and it is not user

programmable.

Determining Which Channels are in Scan List

Channels in the radio wide and conventional standard scan lists are

determined as follows. Channels in the SMARTNET/SmartZone standard

scan lists are indicated only when editing a list (see page 25).

1. Enable Standard scanning to view the standard list or Radio Wide scan-

ning to view the radio wide scan list (the procedure is on page 21). With

conventional standard scanning which can have up to three lists, also

select the scan list if applicable as described on page 33.

2. Select the desired zone and then scroll through the channels by rotating

the Select switch. When the displayed channel is in the scan list

(scanned normally), the symbol is displayed next to the zone number

as shown in the following illustration.