User's Manual

GENERAL OPERATION

• To turn scanning off, press the SCAN option switch again and is no

longer indicated in the status display and “SCAN OFF” is briefly

displayed.

• If the zone or channel is changed while scanning is selected, scanning

continues on the same or a different scan list (see page 23).

Radio Wide Scanning

Radio wide scanning monitors the channels in the preprogrammed

radio wide scan list. This list may contain up to 16 channels of any type

assigned to any zone (see scan list description on page 23). Radio wide

scanning is turned on and off by the

RWS option switch as follows. If

this switch is not programmed, radio wide scanning is not available.

• To turn radio wide scanning on, press the RWS option switch and

“RSCN ON” is briefly displayed. In addition, is displayed the same

as with standard scanning.

• To turn radio wide scanning off, press the RWS option switch again

and “RSCN OFF” is briefly displayed and is no longer displayed.

• If the zone or channel is changed while radio wide scanning,

scanning continues normally.

Scan Resume Delay

When a message is received or transmitted while scanning, there is a

system operator programmed delay before scanning resumes. The delay

after receiving a call prevents another message from being received

before you can make a response, and the delay after transmitting a call

ensures that you hear a response to your call instead of another message

occurring on some other channel.

Transmitting in the Scan Mode

If the transmitter is keyed while scanning is enabled, the transmis-

sion may occur on the receive, selected, or priority channel depending on

the operating mode and programming.