Service Manual

December 2008 5300 ES Series Mobile Radio Service Manual 2-3
Radio Programming
2.1.3 Handheld Controller Programming Setup
When the Handheld Control Unit is used, the same computer, RPI, and programming
cable are used as with the standard front and remote models. In addition, the following
components are required:
• The junction box, Part Number 023-5300-130, is required to provide a connection point
for the RPI since the control unit does not have a programming jack. This box may not
be included with some handheld control units.
• Adapter Plug, Part Number 023-5300-140, is required to plug the 5300 programming
cable into the rectangular 10-pin programming connector on the junction box, as shown
in Figure 2.2.
Figure 2.2 Programming Adapter Plug
Only one radio programming parameter must be changed when the Handheld Control Unit
is used. Set the “Controller Type” parameter on the Global tab of the PC Configure
programming software for “Handheld” instead of “Normal”.
2.1.4 Siren Programming
When the optional siren feature is installed (see the 5300 Series Mobile Installation
Manual), one radio programming parameter may need to be changed for proper operation
of the siren controller backlight. On the Global tab of the PC Configure programming
software, set the “Auxiliary B Toggle” parameter for “Backlight”. The Siren Control Head
backlight then turns on and off with the radio control unit backlight.
2.2 Using PC Configure Software
The PC Configure software is described in a separate CD-based manual included on the
CD-ROM with the programming software.
To Junction Box
To Prog Cable