Service Manual

December 2008 5300 ES Series Mobile Radio Service Manual 1-4
General Information
1.1.5 Programming
Radio programming is performed using a PC-compatible computer and an EFJohnson
Technologies Remote Programming Interface (RPI) and PC Configure programming
software (see Table 1.1). Programming is described in the PC Configure Programming
Manual included separately.
1.1.5.1 Alignment
Radio alignment is performed using the same computer and RPI used for programming
(see preceding section) and special PC Tune
™
software. All adjustments are made
electronically using the software (no manual adjustments are required). Alignment is
described in Section 6.
1.2 Model Number Breakdown
The radio model number is located on the radio identification label attached to the side of
the radio.
1.3 Serial Number Breakdown
The radio serial number is located on the radio identification label attached to the side of
the radio. The following is a breakdown of this number:
53xx
Model Revision
Letter
Manufacture
Date
Warranty
Number
Week No.
of Year
Last 2 Digits of Year
T = MTI
PlantFrom P.N.
A = Waseca
C = CTI
12345 X 43 07 H