Service Manual Part 2

ALIGNMENT PROCEDURE
5-4
September 2001
Part No. 001-5100-001
3. When prompted, adjust the output level for 8 dB
SINAD and click OK.
4. Proceed as prompted and when this adjustment is
complete, a message is displayed and the settings
are stored.
5.7 RSSI ADJUSTMENT
NOTE: With some early models, this adjustment
cannot be made using the PCTune software so an error
message is displayed when it is selected.
This adjustment calibrates the RSSI signal level.
Proceed as follows:
1. Connect an RF signal to the antenna jack. Click OK
with “RSSI” selected.
2. Set the generator for the indicated frequency and
output level and click OK.
3. Select the other output levels as prompted. When
this adjustment is complete, a message is displayed
the settings are stored.