Service Manual Part 2

TRANSCEIVER PROGRAMMING
3-20
September 2001
Part No. 001-5100-001
Channel - The physical channel used for dynamic
regrouping. The value is selected on the Channel
Parameters screen.
Affiliation Type
Automatic
- The radio immediately affiliates with the
central controller as soon as it is turned on and auto-
matically re-affiliates each time the talk group is
changed.
On PTT
- The radio affiliates with the central control-
ler only when the PTT switch is pressed.
Time-Out Timer
This programs the time-out timer setting for the
system. It can be programmed for 0 min, 15 sec up to
3 min, 45 sec or it can be disabled (see Section 2.4.10).
ISW Delay
Increasing or decreasing this value changes the
transmission timing of ISWs relative to the reception
of OSWs.
3.6.3 SMARTNET/SMARTZONE SYSTEM
OTHER ID’S SCREEN
The SMARTNET/SmartZone Other ID’s screen
is shown above, and it programs the following
parameters.
Individual ID
- Uniquely identifies the radio on a par-
ticular system. Each radio must have a different Unit
ID. Valid Unit IDs are from 1-63535.
Connect Tone
- The tone expected by the controller
on the traffic channel to verify that a subscriber trans-
mission is occurring. This tone should be set the
same as it is in the controller.
Encryption Key IDs
Programs SecureNet Encryption ID selection that
is used in all except group calls.
System Wide
- Key used for system-wide calls
(typically originated by the dispatcher).
Failsoft
- Key used in failsoft conditions (see Section
2.7.11).
Patch Key Select
- Key used in patch calls.
Unit To Unit
- Key used for unit-to-unit (private)
calls.
Interconnect
- Key used for telephone interconnect
calls.
Dynamic Talk Group
- Key used for the dynamic
regrouping talk group when it is a standard talk
group.
Dynamic Ann. Group
- Key used for the dynamic
regrouping talk group when it is an announcement
group.
3.6.4 SMARTNET/SMARTZONE SYSTEM
PHONE INTERCONNECT SCREEN
The SMARTNET/SmartZone Phone Intercon-
nect screen follows on the next page, and it programs
the following parameters.
Phone Interconnect
Refer to Section 2.7.6 for more information on
telephone calls.
Disabled
- Telephone calls cannot be placed or
received.