Service Manual Part 2

TRANSCEIVER PROGRAMMING
3-19
September 2001
Part No. 001-5100-001
These parameters are programmed the same as
described in Section 3.5.6.
3.6 PROGRAMMING SMARTNET/SMARTZONE
SYSTEMS AND CHANNELS
3.6.1 INTRODUCTION
To program SMARTNET and SmartZone
systems and channels, proceed as follows:
1. Program the SMARTNET/SmartZone radio-wide
information as described in Section 3.4.
2. To create a new SMARTNET/SmartZone system,
select the Systems > Add Systems in the menu bar
(see Section 3.1.11). Up to sixteen systems of any
type can be programmed as described in Section
1.2.5.
3. Program the SMARTNET/SmartZone system infor-
mation as described starting in the next section.
Make sure the desired SMARTNET or SmartZone
system is displayed by clicking it in the left pane or
selecting it in the Window menu in the menu bar
(see Section 3.1.9). Then program the channels as
described starting in Section 3.6.8.
3.6.2 SMARTNET/SMARTZONE SYSTEM
GENERAL SCREEN
The preceding SMARTNET/SmartZone System
General screen programs the following parameters:
Restricted Access
Change System ID Button
- Displays the Change
System ID screen which is used to enter the system
ID of the system. This ID is entered as a hexadecimal
number from 0-9 and A-F. Valid numbers are from
0001-FFFF. The system ID corresponding to the
desired ID must also be located in the “key” subdi-
rectory of the program file.
System ID
- Read-only field which shows the ID of
the system currently being edited.
Splinter Channels
When splinter channels are enabled, the receive
and transmit frequencies are 12.5 kHz lower than the
normal frequencies. Splinter channels are used only as
required in the Mexico and Canada border areas for
frequencies between 806 and 820.975 MHz.
Channel Modulation
When “Wideband” is enabled, the radio operates
with a 4 kHz maximum deviation between 821.000
and 824.975 MHz and 5 kHz maximum deviation for
all other frequencies. When it is disabled, deviation is
5 kHz with all frequencies.
System Lists Button
This button displays the screens used to program
the various per system lists. Refer to Section 3.6.7 for
more information on these lists.
Dynamic Regrouping
Enable For This System
- When this box is checked,
a dynamic regrouping channel is enabled. This is a
SMARTNET channel which has the corresponding
talk group dynamically set by the dispatcher.
Zone
- The physical zone containing the dynamic
regrouping channel. The value is selected on the
Channel Parameters screen.