Service Manual Part 1
OPERATION
2-26
September 2001
Part No. 001-5100-001
Figure 2-3 Keypad Programming Flowchart
RAD
PA RM
Clone?
Rx Freq
Tx Freq
Rx CG/NAC
Tx CG/NAC
Tx Power
TOT On-Off
*
#
Zone No.
ZONE x
CLR key
CHAN xx
#
*
#
#
#
#
#
#
#
Wide/Nar Band
#
Tx Timer
Penalty Timer
Conver. Timer
#
#
#
*
*
*
#
Six Beeps
• The paged radio received the page and acknowl-
edged it (Section 2.7.7).
• The message that was sent has been received and
acknowledged (Section 2.7.8).
• The status condition that was sent has been received
and acknowledged (Section 2.7.9).
Two Beeps
• The emergency alarm condition was acknowledged
(Section 2.7.10).
Gurgle-Like Tone
• Dynamic regrouping has occurred (Section 2.7.13).
• Dynamic regrouping has occurred but the
regrouping channel is not selected (Section 2.7.13).
Four Low Tones (Busy Signal)
• The radio system is busy or a busy condition exists
when making a telephone call.
Four Alternating High and Low Tones
• A channel is available after a busy condition
occurred (SMARTNET/SmartZone only).
2.9 KEYPAD PROGRAMMING
2.9.1 INTRODUCTION
Keypad programming is available with full
keypad (18-key) models if the Keypad Programming
option switch is programmed. It is then selected by
pressing this switch and entering the programming
password. This password is a series of eight digits
selected preprogrammed using PCTrunk, and it
prevents unauthorized changing of radio program-
ming. The default password is eight zeros, and the
ENT (F4) key must be pressed after the digits are
entered. This password is not user reprogrammable.
Keypad programming allows conventional
channel parameters such as the transmit and receive
frequency and Call Guard squelch code to be changed.
In addition, several conventional mode timers can be
programmed. It cannot be used to reprogram disabled
or SMARTNET/SmartZone channels.
2.9.2 MENU STRUCTURE
When the Keypad Programming mode is selected
by pressing the option switch and entering the pass-
word, “
Pgm” is displayed along with the first menu
parameter “RAD PARM”. The flowchart in Figure 2-3