Service Manual Part 1

GENERAL INFORMATION
1-6
September 2001
Part No. 001-5100-001
5100 SERIES PORTABLE SPECIFICATIONS
The following are general specifications intended for use in testing and servicing this transceiver. For current
advertised specifications, refer to the specification sheet available from your sales representative. Values are
typical and are subject to change without notice.
GENERAL
Operating Modes Project 25 conv. and trunked, SMARTNET,
SmartZone, Conventional analog,
Multi-Net
Zones/Channels 16 zones with 16 channels per zone
Transmit/Receive Separation Any frequency within the range
Channel Spacing 800 MHz: 12.5 and 25 kHz
Maximum Deviation 25 kHz analog - 5 kHz
12.5 kHz analog NPSPAC - 4.0 kHz
Frequency Stability 1.5 PPM –22° to +140° F (–30° to +60° C)
Dimensions (w/o antenna) 6.7” H x 2.52” W x 1.9” D (17.0 cm x 6.4 cm x 4.8 cm)
Weight (w/std battery) 24 oz. (675 g)
Supply Voltage 7.5 volts DC nominal
Battery Life 13 hours typical w/std 3300 mAH NiMH battery
Current Drain (maximum) Standby - 110 mA
Receive (rated audio out) - 350 mA
Low Tx Power - 1.2 A
High Tx Power - 2.6 A (800 MHz)
RECEIVER
Sensitivity 0.35 µV (analog mode 12 dB SINAD), 0.35 µV (digital mode 5% BER)
Selectivity 60 dB
Spurious and Image Rejection 65 dB
Intermodulation 70 dB
Hum and Noise 40 dB at 25 kHz, 34 dB at 12.5 kHz
Maximum Frequency Spread Any spread within the range
Audio Power Output 500 mW
Audio Distortion Less than 5% at 1 kHz
TRANSMITTER
Spurious and Harmonic Emissions 60 dB
FM Hum and Noise 40 dB at 25 kHz bandwidth
Audio Modulation 14K0F3E, 16K0F3E, 8K10F1E
Audio Distortion Less than 3% at 1 kHz
Maximum Frequency Spread Any spread within the band
Frequency Range 800 MHz 806-870 MHz
RF Power Output 800W: 3W