Operator's Manual

SMARTNET/SMARTZONE FEATURES
61
2. To reset all talk and announcement groups to normal so that only the
designated regrouping channel is on the dynamic group, manually
select the designated regrouping channel if you know it. If this channel
is not selected or there is no designated regrouping channel, all trans-
missions occur on the dynamically assigned group regardless of which
channel is selected, and the regrouping tone sounds each time the PTT
switch is pressed.
3. When regrouping is canceled by the dispatcher, transceiver operation
returns to normal.
SmartZone Features
Introduction
As described starting on page 28, the SmartZone
®
mode provides
wide area coverage by allowing roaming between SMARTNET and
conventional sites. SmartZone operation is the same as SMARTNET with
the following additional features.
Determining Current Site
To determine the current radio site, momentarily press the Site
Search option switch (if programmed). If currently registered on a site,
“SITE x” is displayed, where “x” is the site number. The display then
indicates the RSSI (Receive Signal Strength Indicator) value of the
current site as “RSSI x” and then returns to displaying the channel alias.
Searching For a New Site
To search for a new site, press the Site Search option switch (if
programmed) to toggle through the available sites. “RSSI x” is displayed
as just described and the channel alias is then displayed.
Locking/Unlocking a Site
It is sometimes desirable to stay on the current site regardless of
signal level. To lock the radio on the current site so that it does not search