Operator's Manual

Table Of Contents

CONVENTIONAL FEATURES

toggle between “WIDE” and “NARROW”, and when the desired setting

is displayed, save it and proceed to the next parameter by pressing the

# key.

Receive Frequency - When the

Rx icon is indicated to the left of Pgm

and a frequency or eight zeros is displayed, the receive channel frequency

can be programmed. Press the

F3 key to clear the current frequency and

then type in the new frequency. When the desired frequency is displayed,

save it and proceed to the next parameter by pressing the

F4 or # key.

Transmit Frequency - When the

Tx icon is indicated to the left of Pgm

and a frequency or eight zeros is displayed, the transmit frequency is

programmed the same as the Receive Frequency above.

Squelch Control (Analog Channels)

Receive CTCSS/DCS - When “TN xxxx” or “DIG xxx” is displayed

with the

Rx icon indicated to the left of Pgm, the receive Call Guard

(CTCSS/DCS) code can be programmed. Press the

F3 key to clear the

current code and toggle between the CTCSS (tone) and DCS (digital)

modes. Press the Up/Down select switch to scroll through the avail-

able codes. When the desired code is displayed, save it and proceed to

the next parameter by pressing the

F4 or # key.

Transmit CTCSS/DCS - When “TN xxxx” or “DIG xxx” is

displayed with the

Tx icon indicated to the left of Pgm, the transmit

Call Guard (CTCSS/DCS) code can be programmed the same as the

Receive CTCSS/DCS above.

Squelch Control (Project 25 Channels)

Receive NAC - When “NAC xxx” is displayed with the

Rx icon indi-

cated to the left of

Pgm, the receive Network Access Code (NAC)

can be programmed. This can be any number from 0-4095. Press the

F3 key to clear the current code and then enter the desired code using

the number keys. When the desired code is displayed, save it and

proceed to the next parameter by pressing the

F4 or # key.