Operator's Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- FEATURES
- TABLE OF CONTENTS
- OPTION SWITCH FUNCTIONS
- CONTROLS AND DISPLAY
- GENERAL OPERATION
- CONVENTIONAL FEATURES
- Introduction
- Display Mode Selection
- Monitoring Before Transmitting
- Monitor Mode
- Busy Channel Lockout
- Call Guard Squelch
- Penalty Timer
- Conversation Timer
- Repeater Talk-Around
- Power Output Select
- Emergency Mode (Conventional)
- Conventional Mode Scanning
- Priority Channel Sampling
- Placing and Receiving Standard Conventional Calls
- DTMF/ANI Signaling
- Project 25 Mode Features
- Keypad Programming
- Channel Parameter Programming
- SMARTNET/SMARTZONE FEATURES
- MISCELLANEOUS
- INDEX
OPTION SWITCH FUNCTIONS
11
OPTION SWITCH FUNCTIONS
The programmable option switches are as follows:
• F1, F2, F3, and F4 keys on the front panel
• Three push-button switches on the side
• Orange push-button switch on the top panel
• Three-position A/B/C switch on top panel
These switches can control one function when a conventional
channel is selected and another when a SMARTNET/SmartZone channel
is selected. The available functions for each operating mode and the page
on which each function is described are listed in the following tables.
Consult your system operator to determine what functions are controlled
by each switch and then write the switch label next to the applicable func-
tion. Refer to page 20 for more option switch information.
CONVENTIONAL MODE
Switch Function See Page
Backlight 20
Clear/Secure 28
Displayed Information 30
High/Low Power 34
Home Zone 22
Individual ID Call 40
Keypad Lock 21
Keypad Programming 40
Monitor 31
Normal/Selective 32
Priority 36
Radio Wide Scan 24
Repeater Talk-Around 34
Scan 24
Scan Edit 26
Talk Group Select 39
Tones On-Off 23
Zone Select 21