User Manual
Table Of Contents
- SAFETY TRAINING INFORMATION
- TABLE OF CONTENTS
- FEATURES
- CONTROLS AND DISPLAY
- GENERAL OPERATION
- RADIO-WIDE FEATURES
- CONVENTIONAL MODE FEATURES
- Monitoring Before Transmitting
- Monitor Mode
- Busy Channel Lockout
- Call Guard Squelch
- Penalty Timer
- Conversation Timer
- Repeater Talk-Around
- Displaying Transmit and Receive Frequency
- Emergency Mode
- Conventional Mode Scanning
- Priority Channel Sampling
- Placing and Receiving Conventional Calls
- Project 25 (Digital) Mode Features
- Keypad Programming
- SMARTNET/SMARTZONE FEATURES
- SUPERVISORY TONES
- INDEX
SUPERVISORY TONES
31
May 2002
Part No. 002-5100-100
• An out-of-range condition exists (SMARTNET/
SmartZone only).
• A transmission is being attempted before the penalty
timer has expired (page 17).
• Dynamic regrouping has been exited but the
dynamic regrouping channel is still selected
(page 29).
Single Short Medium-Pitch Tone
• A valid key has been pressed.
Single Short Low-Pitch Tone
• An invalid key has been pressed.
Medium Tone (No Acknowledge)
• The paged mobile did not acknowledge the page
(page 27).
• The message that was sent has not been acknowl-
edged (page 28).
• The status condition that was sent has not been
acknowledged (page 28).
Five Beeps (Recurring)
• The page was received (page 27).
Two Short Tones
• A private call was received (page 24).
Five Beeps
• The paged mobile received the page and acknowl-
edged it (page 27).
• The message that was sent has been received and
acknowledged (page 28).
• The status condition that was sent has been received
and acknowledged (page 28).
Four Beeps
• The emergency alarm condition was acknowledged
(page 28).
Alternating Tone
• Dynamic regrouping has occurred (page 29).
• Dynamic regrouping has occurred but the
regrouping channel is not selected (page 29).
Busy Signal
• The radio system is busy or a busy condition exists
when making a telephone call.
Three Medium Pitch Tones
• A channel is available after a busy condition
occurred (SMARTNET/SmartZone only).