Operating Manual

March 2008 5100 ES Models II/III Portable Radio Operating Manual 7-3
Miscellaneous
Kypd Lockd - The keypad lock function is active and key presses are not accepted in
this mode.
Kset Fail - The encryption key set chosen by the user is not valid.
List Only - Direct entry of a unit ID or phone number is disabled.
Locked - A selector lock command has been received and zone and channel changes
are not accepted.
Lost Signl - Signal from the infrastructure has been lost during an interconnect call.
Low Power - The current channel is strapped to low power and that the user can not
select high power at this time.
Msg Failed - The message sent to the system was not acknowledged.
Narrow - The current conventional channel is programmed as a narrow channel.
No Ack - The radio did not receive an Acknowledgement for the current signaling
attempt.
No Edit - The current list is not able to be edited.
No Encrypt - Encryption is not available for the selected channel.
No List - No list is available for the selected channel.
No Message - No message is programmed for transmission.
No Reply - Radio cloning failed due to no response.
No Service - OTAR service is not available.
No Site - No site with a verified ID is yet on the dynamic site list.
No Keys - No keys are available for the key select function.
Out Of Rng - This error indicates no control channel has been found for trunking
operation.
Parms Fail - The checksum of the profile / user parameters does not match the
calculated checksum. This indicates that there is an error in the parameters file. This
message only occurs if the redundant copy of the parameters is also corrupt or is unable
to be used.
Rekey Fail - This error indicates a failure in a rekeying process.
Rx Only - The selected channel is Rx only.
Sts Failed - No acknowledgement was received while sending a status report.
Timeout - A time out has occurred in attempting the current function.
Too Hot - The mobile has passed the “Too Hot” temperature threshold. Under these
conditions the radio will not allow Tx.
Tx Timeout - The Tx time-out timer has expired and Tx has been terminated.