Operating Manual

7-2 5100 ES Models II/III Portable Radio Operating Manual March 2008
Miscellaneous
Busy - A call has been attempted and the system has responded that no channels are
available for assignment.
Busy Tmout - The radio previously received a busy response from the system and it
has not received a channel grant before the busy time-out timer has expired
Disabled - The selected channel is disabled.
Clear Only - The selected channel or group is strapped clear only and a secure call can
not be made.
Corupt Prm - The radio has detected that its profile/user parameters are not valid
because the functional blocks cannot be identified.
Cycle Power - This error replaces the previous RX Back End Fail error. It occurs when
the radio has a communication failure with the RF Deck. This error only occurs with the
X and G radio platforms.
Denied - A group call attempt has received a Denied response from the system.
Deny - A unit or interconnect call attempt has received a Denied response from the
system.
Disabled - The feature that the user is attempting to use has been disabled on the radio
either by programming or by factory options.
DSP Failed - The main processor and the DSP have failed to complete their startup
procedure at powerup.
EEPRM Fail - The main processor has timed out while trying to validate or invalidate
the profile/user parameters in the EEPROM.
Encryp Bad - The main processor and the Encryption Module have failed to complete
their startup procedure at power up.
Fixed High - The selected channel or group is strapped to high power and thus low
power can not be selected.
Fixed Low - The selected channel or group is strapped to low power and thus high
power can not be selected.
Too Hot - The mobile has passed the hot temperature threshold. Under these conditions
the radio will only transmit in low power.
Invalid - The received input from the user does not fit the criteria necessary for the
feature.
Invalid ID - The received ID from the user was not a valid ID.
Invald Key - The key pressed by the user was not valid for the current situation.
Invld Ch - The channel entered by the user in keypad programming is not valid.
Key Fail - The encryption key required by the current selected group/channel is not
valid.