Operating Manual

March 2008 5100 ES Models II/III Portable Radio Operating Manual 7-1
S ECTION
Section 7Miscellaneous
7.1 Error Messages
The following are definitions of the various error messages that may be displayed.
Aff Failed - A group affiliation attempt has received a Failed response from the system.
The precise reason for a Failed response is manufacturer dependent.
Aff Deny - A group affiliation attempt has received a Denied response from the system.
The precise reason for a Denied response is manufacturer dependent. One common
cause is that the group is disallowed on the site/RFSS that the radio is attempting to
affiliate on.
Aff Refusd - A group affiliation attempt has received a Refused response from the
system. The precise reason for a Refused response is manufacturer dependent.
Answr Only - The user has attempted to initiate a private call or interconnect call and
the feature is programmed for answer only.
Bad Band - A profile/or user parameters have been downloaded with PC Configure
that are for a band different from the hardware of the radio.
Bad ESN -The ESN of the radio is not valid. This error is usually only seen in the
factory when first programming brand new logic boards.
Bad Fl Fmt - A profile/or user parameters have been downloaded to the radio that do
not match the file format supported by the firmware/software in the radio. This message
may appear on initial power up following a firmware upgrade. In such cases the
message can be cleared by doing a read/write of parameters using PCC version 2.6.x or
later.
Bad Hrdwar - The ESN of the radio is not valid. This error is usually only seen in the
factory when first programming brand new logic boards.
Batt Low - The battery voltage has been detected as being low.