Operating Manual

March 2008 5100 ES Models II/III Portable Radio Operating Manual 6-15
SMARTNET / SmartZone / P25 Trunked Features
• Scanning is turned on and off by the Scan option switch or menu parameter. Talk
groups (channels) can be programmed so that scanning automatically starts when the
talk group is selected (Autoscan).
• When responding to calls in the scan mode, the programming of the Talkback Scan
parameter determines if a response always occurs on the talk group of the call (Active
Group) or the Selected Group if they are different. Transmissions at other times always
occur on the selected talk group.
• Each talk group can be programmed to select one of the programmed scan lists or “No
List” (scanning is disabled). If scanning is enabled and the selected channel does not
permit scanning, it is automatically enabled again when a channel is selected that
permits scanning.
• Up to 255 scan lists, each with up to 255 talk groups from the same system can be
programmed. The selected scan list can be temporarily changed and edited as described
in Section 4.10.1.
• In addition to calls on channels in the scan list, pages, private/unit calls, and telephone
calls are received while scanning. Private and telephone calls are not interrupted by
priority messages.
Every radio on the system has to register with he Zone or Site Controller so that the system
knows where everyone is and if traffic from one site needs to be sent to another site. This
is determinned by the list of talkgroups associated with the radio.
When a call needs to be passed to a radio at another site, the traffic from one site to
another is sent out over the control channel to the radios. When a radio is scanning, it is
monitoring the call information being sent out over the control channel. The radio
compares the call information (talkgroup and voice channel handling the talkgroup) to the
scan list to see if any of the talkgroups it is scanning are receiving a call. If it finds a
match, the radio moves to the voice channel for this call. If no one is registered on a
talkgroup on the site being scanned, the call information for the call is not sent out by the
Control Channel (because the Zone or Site Controller did not see a requirement to pass the
information for this call) and the call will not be received.
For example: Radio 1 is on a call on talkgroup 1 on Site 1, Radio 2 is on talkgroup 2 on
Site 2 and scanning. The call on talkgroup 1 from radio 1 is not heard by radio 2. Then, if
radio 3 registers on talkgroup 1 on site 2, the call from radio 1 on site 1 will go to site 2.
Radio 2, radio 3, and any other radios on site 2 and scanning, will hear the call.
6.11.1 Priority Talk Group Sampling
The 5100 ES radio supports Dual Priority talk groups in all trunking and conventional
formats.