Operating Manual

March 2008 5100 ES Models II/III Portable Radio Operating Manual 6-5
SMARTNET / SmartZone / P25 Trunked Features
- If your radio or the called radio is inhibited or not programmed to make this type of
call or for the requested secure mode, “Rspns Only” is displayed and an alert tone
sounds.
- If your radio does not have the proper encryption key, “Keyfail” is displayed and the
call must be made in the clear mode by pressing the Clear/Secure option key (if
strapped to switchable). Otherwise, load the correct key.
4 When the call is finished or is not answered, end it by pressing the Private Call option
key or the <F1> (Exit) key.
6.4.2 Placing a Standard Private Conversation Call
To recall from a list:
1 Momentarily press the Private Call option key or select that menu parameter. The alias
of the last called radio is displayed, and the private call mode is indicated by
in
the display.
2 If required, select another radio by pressing the Up/Down switch until the alias of the
desired radio is displayed.
3 Press the PTT sw or the <F2> key to initiate the call.
(Proceed to the bulleted list which follows Item 3 in the next section for events that may
occur next.)
To make a direct entry using DTMF keypad:
1 Press and hold the Private Call option key until a tone sounds (approximately one
second). The last ID called is displayed, and the private call mode is indicated by
in the display.
2 Using the 0-9 keys, dial the ID of the radio you are calling (five digits for Private calls
and eight digits for Unit calls). To erase the last digit, press the Down key, and to
cancel the call, press the Private Call Option key again.
3 Press the PTT switch to initiate the call. If the entered number is valid, the display
indicates the alias of the ID if it matches an ID in the call list. Otherwise, the ID you
entered continues to be displayed.
Events that may then occur are as follows:
- The called party answers the call.
- The called party does not answer. Press the Private Call option key or <F1> (Exit) to
end the call.
- If the selected radio ID is not valid, “Invalid ID” is displayed and an alert tone
sounds.