Operating Manual

5-12 5100 ES Models II/III Portable Radio Operating Manual March 2008
Conventional Mode Features
Priority channel sampling occurs only with conventional priority scanning. It does not
occur with radio wide scanning, when listening to any type of SMARTNET/SmartZone/
P25 trunked call, encrypted call, or when transmitting (see preceding note). A series of
“ticks” may be heard when the priority channel is sampled while listening to a message on
some other conventional channel.
The priority sampling times are programmed by the following parameters:
Lookback Time A - This time determines how often the priority channel is checked for
activity. Times of 0.25-4.00 seconds in 0.25-second steps can be programmed.
Lookback Time B - This time determines how often the priority channel is checked
once an incorrect Call Guard (CTCSS/DCS) or NAC code is detected. Since it takes
much longer to detect an incorrect Call Guard signal than a carrier, this time should be
relatively long to prevent the interruptions from making a message difficult to
understand. Times of 0.5-8.0 seconds can be programmed in 0.5-second steps.
5.10.2.1 Changing the Priority Channel
If a fixed priority channel is associated with the current scan list, it can be changed if the
Priority option switch or menu parameter is programmed. With dual priority, this function
changes only the first priority channel. To change both priority channels, use the Scan List
Edit function described in Section 4.10.1.
Proceed as follows to change the priority channel using the Priority option switch/menu
parameter:
1 Make sure scanning is disabled ( icon not displayed) and the desired scan list is
selected (see Section 4.10).
2 Select the channel you want to be the priority channel and then press the Priority option
switch or select that menu parameter. “Priority” is then flashed to indicate that the
current channel is now the priority channel when scanning that list. Other indications
that may occur are as follows:
- If “No Priority” is displayed, priority sampling may not be enabled on the scan list.
- If “Sel Chan” is displayed, the priority channel is always the selected channel and
cannot be changed.
- If no indication displayed, the scan list may not be user editable or the channel may
not be in the scan list.