Operating Manual

March 2008 5100 ES Models II/III Portable Radio Operating Manual 4-11
Radio-wide Features
If the Scan (List) Select option switch or menu parameter is programmed, the list that is
selected by all talk and announcement groups in the current system can be temporarily
changed by the user as follows. “No List” (scanning disabled) or “Programmed” (default
list) can also be selected if desired. The temporary programmed scan list is retained
through radio power down.
To change the currently selected scan list (all channel types), proceed as follows:
1 With scanning disabled ( icon not displayed), press the Scan List option switch or
select the Scan Selct menu parameter.
2 The currently selected list is displayed as “List x”, where “x” is the currently selected
list. To exit without changing the selected list, simply press the Scan List option switch
again or the <F1> key.
3 To select another list, press the Up/Down switch. When the desired list is displayed,
select it and exit this mode by pressing the Scan List option switch again or the <F1> or
<F2> key.
4.10.1.3 Editing a Priority Scan List
If the Scan Edit option switch or menu parameter is programmed, conventional,
SMARTNET/SmartZone, and P25 Trunked priority (standard) scan lists can be user
programmed. Changes are permanent (cycling power does not reselect a default
condition). Proceed as follows:
1 Make sure that both priority and radio wide scanning are off ( icon not displayed).
Select a conventional or SMARTNET/SmartZone/P25 Trunked channel corresponding
to the scan list being programmed.
2 Select the scan edit mode using the Scan Edit option switch or menu parameter. This
mode is indicated by
in the display.
3 If applicable, select the list to be edited by pressing the Up/Down switch. Select the
desired list by pressing the <F2> key. The selected list is indicated as “List x”. If user
programming is disabled on a list, (conventional only) “No Edit” is momentarily
displayed and it cannot be edited.
4 Select the channel you want to add or delete by pressing the Up/Down switch. After the
last channel in the current zone is displayed, the first valid channel in the next zone is
displayed and vice versa. Lists are limited to 256. If an attempt is made to add more
than that, “List Full” is displayed and a channel must be deleted before another can be
added.
Note Priority channels can be deleted.
5 If the selected channel is in the scan list (scanned), the icon is displayed. To
change the status of the displayed channel, press the <F2> (Enter) switch.