Operating Manual

3-10 5100 ES Models II/III Portable Radio Operating Manual March 2008
General Operation
Do not expose the charger base to high level RF signals while a battery is being charged
because this may cause a charger fuse to blow (especially in the UHF range). Radios
programmed for SMARTNET/SmartZone operation, for example, may affiliate while in
the charger which causes them to automatically key. Therefore, do not leave radio power
on while charging as described above.
3.4.4 Beltclip Installation
Remove the battery and slide the belt clip into the slot on the battery as shown below. To
remove the clip, simply slide it out. It is held in place by the chassis when the battery is
installed on the radio
Figure 3.2 Beltclip Installation
3.4.5 Connecting an Accessory
To connect an accessory to the transceiver, proceed as follows:
1 Remove the protective cover over the accessory jack on the side of the transceiver.
2 Insert the hook on the lower end of the accessory connector into the slot on the side of
the transceiver.
3 Rotate the latch open, press the connector against the transceiver, and then release the
latch to lock the connector in place.