User Manual Part 1

8
programming software displays a bar graph which shows the amount of available memory space
that is used by the current data. Refer to Section 4 for more information.
Zones
A zone is a collection of up to 16 channels of any type. For example, a zone could include 12
conventional channels and 4 SMARTNET channels. One use of zones may be to program the
channels used for operation in a specific geographical area. Up to 16 zones can be programmed.
1.2.6 PROGRAMMING
Transceiver programming is performed using a PC-compatible computer and an EFJohnson
Remote Programming Interface (RPI) and PC Configure programming software (see Table 1-1).
Programming is described in a separate included manual. Refer to Section 4 for more
information.
1.2.7 ALIGNMENT
Transceiver alignment is performed using the same computer and RPI used for programming
(see preceding section) and special PCTune
™
software. All adjustments are made electronically
using the software (no manual adjustments are required). Alignment is described in Section 6.
1.3 PRODUCT WARRANTY
The warranty statement for this transceiver is available from your product supplier or from
the Warranty Department, E.F. Johnson Company, 1440 Corporate Drive, Irving, TX 75038-
2401. This information may also be requested from the Warranty Department by phone as
described in Section 1.7. The Warranty Department may also be contacted for Warranty Service
Reports, claim forms, or any other questions concerning warranties or warranty service.
1.4 MODEL NUMBER BREAKDOWN
The radio model number is located on the radio identification label attached to the bottom
cover (see Figure 1-1). The following is a breakdown of this number:
[Insert label graphic here]
Figure 1-1 Identification Label Example
242-5MFT-SEC-OADE