User Manual Part 1

41
SECTION 4 TRANSCEIVER PROGRAMMING
4.1 GENERAL
4.1.1 PROGRAMMING SETUP
The following items are required to program the transceiver. The part numbers of this
equipment are shown in Table 1-1 in Section 1. The programming setup is shown above.
• A Windows
®
-based computer (see next section)
• Remote Programming Interface (RPI), Part No. 023-5300-000
• Programming cable from RPI to transceiver (see Section 4.1.3 for more information).
• EFJohnson PCConfigure programming software, Part No. 023-9998-488.
NOTE: The -005 cable, -000 RPI, -488 software, and a CD manual are included in the 5300
Series Programming Kit, Part No. 250-5000-004. [What are the part numbers of the 4300 parts?]
4.1.2 COMPUTER DESCRIPTION
The computer used to program this transceiver should meet the following minimum
requirements:
.
• Windows 95/98/NT/2000 (3.1 cannot be used)
.
• Pentium
®
processor or equivalent
.
• 16 MB of RAM
.
• A hard disk drive with at least 5 MB of free space