User Manual Part 1

33
transceiver or remote control unit. Refer to Table 2-1 and Section 2.6 for information on how to
set up the control unit for each configuration.
2.9 TRANSCEIVER MOUNTING TRAY INSTALLATION
2.9.1 DESCRIPTION
Optional Transceiver Locking Tray, Part No. 585-7000-185, is a lockable mounting bracket
for 4300 and other transceivers that use the standard chassis. This bracket provides theft
protection and also allows the transceiver to be quickly removed from the vehicle with a key.
2.9.2 INSTALLATION
Refer to Figure 2-9 and proceed as follows:
Figure 2-9 Locking Tray Installation Diagram
1. Install the transceiver in bracket MP2 using the four 10-32 x 1/2” screws (HW2) included. If
desired, this mounting bracket can be used to mount the transceiver directly to the vehicle.
2. Install lock bracket MP1 using the four self-drilling screws (HW3) and washers (HW5)
included. Make sure that there is nothing under the mounting location that will be damaged.
2.9.3 LOCKING/UNLOCKING TRANSCEIVER
To insert the transceiver with attached mounting bracket into the locking bracket, set it over
the locking bracket and push it rearward slightly if necessary so that it seats. Then pull it forward
until it latches. The lock operates in a manner similar to most glove compartment locks. To