User's Manual

>> PS Monitor - Shows the result of a power supply monitor. See Monitors/Faults
for more detail.
-- PS Temp [START/STOP]- Power supply temperature in degrees C.
-- PS Batt Warn
--
- The measurement is TRUE when backup battery level is
sufficient for operation, FALSE when belw the warning level. It is also
TRUE if the backup battery option is not installed.
PS Batt Fail
--
- The measurement is TRUE when backup battery level is
at or above the failed threshold, FALSE when below the failed level. It is
also TRUE if the backup battery option is not installed.
PS AC Fail
--
- The measurement is TRUE when AC is present, FALSE
when AC is not (assuming presence of backup battery).
--
[TOP]
--
[BACK]
--> Alarms - This feature is currently not supported
[BACK]
>> Alarm Tests
--
--
Alarm Input - Test the status of the alarm inputs on the rear of the
chassis. This test is currently not supported.
--
[TOP]
>> Alarm Control
[BACK]
-- Alarm Toggle [Set/Reset] Control the alarm outputs on the rear of the
chassis. This control is currently not supported.
--
--
[TOP]
>> [BACK]
[BACK]
--> Sensor/Other
>> Sensor Tests - Display the raw measurement of the corresponding sensor, in
volts.
-- TX Mod - TX Modulation
-- HS TX Syn Lock - High Stability TX Synthesizer Lock
-- TX Syn Lock - TX Synthesizer Lock
-- AGC - Receiver Automatic Gain Control
-- Gnd - Ground (through resistor)
-- PS Temp - Power Supply temperature sensor.
-- RX WB - RX Wideband.
-- RX RSSI/Q- - Multiplexed RSSI or QRX
-- Inj Lvl - Receiver Injection Level