User's Manual

>> TX Config -Configure the Tx Test. Note that configuration changes will not
take effect until the next time the Tx Test is started.
-- TX Waveform -Select the waveform used during the TX Test; refer to
ANSI/TIA-102.CAAA-A-2002 “Digital C4FM/CQPSK Transceiver
Measurement Methods” for details
• [P25 1011Hz Tn]
• Silence Tone
• P25 Interfrnce
• P25 Busy Patrn
• P25 Idle Patrn
• P25 Cal Patrn
• P25 Inner Dev
• P25 Outer Dev
• P25 c4fmMod Fid
• P25 Auto Freq
• Analog Low Dev
• Analog High Dev
• Silent Carrier
• Station ID
• [TOP]
• [BACK]
-- TX Min Freq MHz -Display minimum tuned TX frequency.
-- TX Max Freq MHz -Display maximum tuned TX frequency.
-- TX Freq -Review/Edit TX Frequency. This frequency is applicable for Tx
Tests and Tx Control. By default, the center of the tuned frequency range
is used.
-- TX Min PA Watt -Display minimum allowed power.
--
TX Max PA Watt -Display maximum allowed power.
-- TX Power -Review/edit TX Power in watts. This power setting is
applicable for Tx Tests and Tx Control. By default, the maximum allowed
power setting is used.
-- Set Keyed [OFF/ON]-Sets transmit state during Tx Tests.
-- Station ID -Review/edit Station ID. Only applicable when Tx Waveform =
“Station ID”
-- Dev Wfrm Param -Configure the modulation amplitude and frequency.
• Low Dev Frq Hz -Configure the modulation frequency for the “Analog Low Dev”
waveform.
• Hi Dev Frq Hz -Configure the modulation frequency for the “Analog High Dev”
waveform.
•
Low Dev Amp Hz -Configure the amplitude for the “Analog Low Dev” waveform.